receiver 433 mhz superheterodyne rf and transmitter module 433mhz remote controls for arduino uno wireless module diy kits
New 433 Mhz Superheterodyne Rf Receiver And Transmitter Module 433mhz Remote Controls For Arduino Uno Wireless Module Diy Kits
138.1 Руб.
5V Super Regenerative Receiver Module/Wireless Receiver Module/Wireless Transmitter Module 433/315MHZ
324.4 Руб.
Taidacent 5PCS 433 MHZ 433Mhz Internal Antenna Lora Wireless RF Transceiver Module Built-in Antennas High Gain Diy
480.11 Руб.
Беспроводной передатчик/приемник DMX с батареей American DJ WiFLY EXR WiFLY EXR Battery Wireless DMX Transmitter/Receiver
29498 Руб.
For DACE Remote Control Garage 433MHz Fixed Code Copy Wireless Transmitter controls for garage doors
207.62 Руб.
New HC-05 6 Pin Wireless Bluetooth Rf Transceiver Module Serial Bt Module Suitable For Arduino
221.52 Руб.
Mini NRF24L01 + 2.4GHz SMD Wireless Transceiver Module for Arduino(5Pcs)2.4G Wireless Transceiver Module
329.96 Руб.
2.4G NRF24L01 Wireless Digital Audio Transceiver Module Transmitter Wifi Sendor/Receiver
1077.01 Руб.
2.4G NRF24L01 Wireless Digital Audio Transceiver Module Transmitter Wifi Sendor/Receiver
7946.91 Руб.
Микроконтроллер PIC16F628A-I/P DIP18, 16F628A MCU 2048x14 FLASH, 224b RAM, 512b EEPROM, ISP
760 Руб.
Описание:
Микроконтроллер от Microchip: 2048x14 FLASH, 224b RAM, 512b EEPROM, ISP.High Performance RISC CPU:• Operating speeds from DC - 20 MHz• Interrupt capability• 8-level deep hardware stack• Direct, Indirect and Relative Addressing modes• 35 single word instructions- All instructions single cycle except branchesSpecial Microcontroller Features:• Internal and external oscillator options- Precision Internal 4 MHz oscillator factorycalibrated to ±1%- Low Power Internal 37 kHz oscillator- External Oscillator support for crystals andresonators.• Power saving SLEEP mode• Programmable weak pull-ups on PORTB• Multiplexed Master Clear/Input-pin• Watchdog Timer with independent oscillator forreliable operation• Low voltage programming• In-Circuit Serial Programming (via two pins)• Programmable code protection• Brown-out Reset• Power-on Reset• Power-up Timer and Oscillator Start-up Timer• Wide operating voltage range. (2.0 - 5.5V)• Industrial and extended temperature range• High Endurance FLASH/EEPROM Cell- 100,000 write FLASH endurance- 1,000,000 write EEPROM endurance- 100 year data retentionLow Power Features:• Standby Current:- 100 nA @ 2.0V, typical• Operating Current:- 12 µA @ 32 kHz, 2.0V, typical- 120 µA @ 1 MHz, 2.0V, typical• Watchdog Timer Current- 1 µA @ 2.0V, typical• Timer1 oscillator current:- 1.2 µA @ 32 kHz, 2.0V, typical• Dual Speed Internal Oscillator:- Run-time selectable between 4 MHz and37 kHz- 4 µs wake-up from SLEEP, 3.0V, typicalPeripheral Features:• 16 I/O pins with individual direction control• High current sink/source for direct LED drive• Analog comparator module with:- Two analog comparators- Programmable on-chip voltage reference(VREF) module- Selectable internal or external reference- Comparator outputs are externally accessible• Timer0: 8-bit timer/counter with 8-bitprogrammable prescaler• Timer1: 16-bit timer/counter with external crystal/clock capability• Timer2: 8-bit timer/counter with 8-bit period register, prescaler and postscaler• Capture, Compare, PWM module- 16-bit Capture/Compare- 10-bit PWM• Addressable Universal Synchronous/Asynchronous Receiver/Transmitter USART/SCI